Monday, November 25, 2019

ROCRAIL DEMO PLAN FREE DOWNLOAD

Configuration of Signal S If more lines, locations etc. Both methods may be used in parallel: If I define the same sensor as enter2in for a specific route route from block 1 to block 2 for example and it gets triggered twice I do not get an unexpected in event message. General for an explanation. It is not yet translated completely but should guide you through the first steps. Starting of locos, setting destinations, random automatic, schedules. rocrail demo plan

Uploader: Moogurn
Date Added: 9 March 2008
File Size: 19.12 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 27056
Price: Free* [*Free Regsitration Required]





The sensors get the addresses 1, 2, 3, 4, 5 and 6 in the order of their appearance in the list.

New loco was created. Simulating enter of block 03 6. Other elemenst have to be left clicked first in order to set them activate only one at a time.

The destination block is reached reliably only if no turnoffs are present between the starting block and the destination block or these turnoffs have been locked beforehand. roctail

Rocview with colourful menu. The window title now reads Rocrail: The demo-plan is consisting of four blocks, eight sensors green circlestwo switches points and the connecting tracks. These alternative settings are shown in the figures below.

After selecting Blocks… from the Tables -menu all three blocks of the sample layout are listed: The sensors now should be deactivated again. Two minutes after the schedule was started the loco departs from block In the prompt the ID of the sensor has to be entered.

rocnet:rocdisplay-en - Rocrail | Model railroad | Control system, Model

Only in the latter case the train will enter block There are many different ways to connect a signal. To get a better overview the plan can be enlarged using the zoom. With a click on each switch symbol on the plan displayed in Rocview the position of the switches change. This signal is should be? Rocrail uses a special block symbol to mark a block. The Interface ID is configured in the same way as for switches.

rocrail demo plan

Missing objects for automatic mode and its configuration follow in the last steps:. In the example switch Sw01 will get the switch address 1 see figure above.

rocrail demo plan

None, the status of the bug is updated manually. If, for instance, the first route []-[] is highlighted and subsequently the Switches -tab is selected, the plxn added switch Sw02 is found in the list. Rocview opens and two pop-up dialogues shows up:. The position of a switch on the track plan must match the position of the respective switch on the layout.

For my money, neither of these systems are very user friendly. The loco will start in block 01, will proceed across block 03 and stop in block Simulating in of block 03 7. In the example E03 continues to block 03 which was a random choice between blocks 02 and It has to be set to the correct position if the route is used. Email me about changes to this bug report.

Step-by-Step Tutorial

ECos use the ID instead of the address to identify a loco. Again, do not attempt to close the server window! James, Have you visited the forum and posed your question there?

rocrail demo plan

General for an explanation.

No comments:

Post a Comment